Introduction
The Speed Based Paver Productivity Report provides detailed stop-and-go activity for paving equipment, helping field teams and supervisors monitor operational time, reduce unproductive delays, and improve cycle efficiency.
This report is specifically designed for Off-Road Pavers and Milling Machines working on mainline or lot-based jobs.
Navigation
To access this report:
Go to: MMS > MMS Reports > Speed Based Paver Productivity
Use This Report To:
Track when Pavers or Milling Machines stop and resume movement
View total productive time vs idle and repositioning time
Apply thresholds to filter short stops out of the report
Compare multiple machines of the same Equipment Type
Export and analyze time percentages for performance evaluation
Equipment Display Options
Equipment: Choose Active, Inactive, or All
Asset Type: Must be set to Off-Road (required for report to function)
Report Filters
Equipment: Search for a specific asset
Equipment Type: Choose Paver or Milling Machine to show all matching equipment
Report Start Date / End Date: Choose any custom range (default is current date)
Not Moving Threshold: Filter out brief stops below the set time (default = 5 minutes)
Time Format: Choose either:
Decimal (e.g., 1.75 hours)
Minutes (e.g., 105 minutes)
Click Generate Report to run.
Report Output
Results are grouped by Equipment and include:
Column | Description |
Stopped Moving | Timestamp when the equipment stopped |
Stop Duration | Duration of the stop (must meet threshold to display) |
Started Moving | When the machine resumed forward motion |
GeoZone | Job zone associated with the movement |
Map | Clickable link to view the stop/resume event on a map |
At the bottom of each group, summary totals are displayed for:
Idle Time and Idle Time %
Productive Time and Productive Time %
Repositioning Time and Repositioning Time %
📌 Example: If Not Moving Threshold = 3 minutes, the report only displays stops that last 3 minutes or more.
Notes & Requirements
This report only works with equipment designated as Paver or Milling Machine
Asset Type must remain set to Off-Road
Stops shorter than the selected threshold will not be shown
Repositioning time reflects small movements that are not considered productive (e.g., lining up the next cut)